So you know how, at the end of every year, it’s pretty much traditional to share your sewing goals for the following year? And I’ve had “try making a bra” on there for several of those in a row now? Well, I finally did it.
And to be honest, I’m a little embarrassed to show the results. But in the interest of honesty and lifelong learning and all that, I’m going to do it anyway.
The thing is, it was never going to be anything more than frumpy to some extent, since it’s a nursing bra and therefore pure function over form. I got the pattern from Bra-Makers’ Supply, as it was the only one I could find that wasn’t a little bralette for, shall we say, the less endowed. (Especially when nursing. Ugh.) I had to completely guess at the supplies, since the sizing listed on the website was a bit confusing. So, given that I’m a complete newbie at this particular type of sewing project, I decided to just buy 3 of the large bra supply kits, along with the necessary nursing clips, and hope for the best.
The good news is, that strategy mostly worked. (“Mostly” being the key word.) I had plenty of the band and trim elastics, and enough of the main fabrics to still have scraps left. Though not enough to line the cups. I wasn’t planning to do it to this one anyway, since I wanted to test the fit before I went to all that trouble, but I was hoping to be able to do it with the other two colors. I cut those out this afternoon, and just could not make that work. Oh well, I’ll be having to stuff these with nursing pads anyway.
This was SO fiddly to sew, moreso than any project I’ve done in some time. I guess it could be partially because of having to add that extra cradle bit to make the cups nursing friendly, and then having to wing it on finishing that seam. (It called for a strip of lightweight tricot, but the kit didn’t have it and the supply list didn’t say anything, so I had to just cut a strip of the leftover powernet and try to just make it work.) But mostly, I think it was all the elastic. That, and the seam finishing that left a lot of raw edges showing. I really feel like the whole thing looks sloppy, and if this is something I’m going to continue playing with past these nursing bras, I’m definitely going to have to clean up my technique.
Aside from that inside cup finishing, the place where the bra kit really didn’t quite cover it was the straps. I suspected I’d be in trouble as soon as I pulled it out and saw just how short the strap elastic length was–it looked like barely enough for one, and I really wasn’t sure I’d be able to get two. I just managed to squeak it out, by adding a bit of extra length using the underwire casing that I hadn’t actually needed for this pattern. As you can see, there is virtually zero adjustability to this strap. So for the next two, I think I’ll be lengthening the casing bit.
I’m not about to put pictures of me actually wearing this thing on the internet, so as far as fit goes, I’ll say it’s probably good enough. If this was more of an everyday bra, I’d say that it really should have some more lift to it, but since this is one where my size will be changing multiple times a day and the underwires were problematic with my store-bought nursing bras, it’s fine. I’m actually wearing it right now, and it’s way more comfortable than my non-nursing bras that I’ve been forced to make work, and still more supportive than my saggy baggy older nursing bras. So in that, at least, it’s a win.
As stated, I did cut out two more today, and am hoping to get them knocked out before this baby actually arrives. It’s cutting it close, as I can only sew in short bursts before I just get too uncomfortable now. (But then, the same goes for everything else in my life right now, so…) And I’ve only got about 3 1/2 weeks before my due date, so wish me luck. Also, any of you more experienced lingerie makers have any tips for how I can get this elastic to stitch on a little nicer? Or what to do with the seam finishing to make this look better?